911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
/f6-3.6l_turbo/Page-892003.png)
1. Insert the stopwatch into the holder and attach it.
2. Position the cover and screw down with the fastening screws.
3. Insert electrical connector into stopwatch until it is felt to engage.
4. Run electrical lead into the dashboard, position the stopwatch with its cover over the dashboard and clip in the four clips.
Programming stopwatch
Reading out and writing stopwatch values
WARNING:
Sudden voltage interruption of the power supply to the control module.
-
Destruction of the control module.
-
During programming, it is essential to guarantee the power supply for the Porsche System tester. It is essential to connect a battery
charger with a current rating of at least 40 A to the vehicle battery.
-
Prior to disconnecting the control module, switch off the ignition and remove the ignition key.
INFORMATION:
-
The PIWIS Tester 9718 instructions take precedence since the description may be different. This may be due to more recent software versions.
-
The procedure described here has been structured in general terms; different text or additions may appear in the PIWIS Tester 9718.
