911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1. Unscrew fastening nut -1-.
2. Remove the holder for the two refrigerant lines and pull the refrigerant line condenser-fluid tank out of the expansion valve.
3. Unscrew the fastening nut -2- for the refrigerant line condenser-fluid tank in front of the fluid tank, detach the line from the holder and pull out
from under the water hoses for the heat exchanger.
Installing the condenser-fluid tank line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
1. Lay the refrigerant line under the heat exchanger hoses and screw down on line to fluid tank -2- with fastening nut. - Tightening torque: 20 Nm (15
ftlb.)
2. Clip line into the holder.