911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1. Unscrew the fastening screw -2- on the compressor.
2. Unscrew the fastening screw -3- at the disconnection point ahead of the rubber mounting and remove the line from the engine compartment.
Installing compressor-condenser line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
1. Carefully insert the line into the engine-compartment disconnection point and fasten with the fastening screw -3-. - Tightening torque: 14 Nm (10.5
ftlb.)