911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
/f6-3.6l_turbo/Page-569034.png)
22. Push plug connection for main wire harness to rear wire harness -1- together at left and right.
22.1. Push plug connection for main wire harness to rear wire harness -1- together and lock it.
Installing wire harness for auxiliary stop light (Cabriolet)
1. Route wire harness for auxiliary stop light and push together wire harness plug connection for auxiliary stop light to rear wire harness -3-.
1.1. Press wire harness for auxiliary stop light into fastening part -arrow A-.
1.2. Push together plug connection between wire harness for auxiliary stop light and rear wire harness -arrows B-.
1.3. Fasten wire harness for auxiliary stop light with two new tie-wraps.
2. Fit rubber sleeve -2- of the wire harness for auxiliary stop light and fasten wire harness for auxiliary stop light.
2.1. Slide in wire harness for auxiliary stop light from below into the convertible top compartment lid and fit rubber sleeve -arrow A-.
2.2. Push on wire harness for auxiliary stop light with the holder onto the convertible top compartment lid -arrow B-.
Installing wire harness for roll-over protection system (cabriolet)
