911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
1. Position wire harness for roll-over protection system -1- on the frame and clip in at the retaining clips -4-.
2. Push in plug connections for rear side panel flap -2- at left and right until they engage securely.
3. Push in hardtop mount plug connection -3- until it engages securely.
Completing the vehicle
1. Insert insulating elements in the area of the rear wire harness.
2. Install mounting saddle for rear-seat backrest.
2.1.Position mounting saddle for rear-seat backrest -2- and secure with the two fastening screws -1-. - Tightening torque: 10 Nm (7.5 ftlb.)
3. Install left and right support.
3.1. Position the support and engage in lower side member.