911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
2. Fit fuel lines.
2.1. Screw fuel line (a/f 17 and 19) onto fuel collection pipe and tighten it.
Tightening torque: 30 Nm (22 ftlb.)
2.2. Screw fuel line onto pressure regulator and tighten it.
Tightening torque: 30 Nm (22 ftlb.)
3. Attach cable rail.
3.1. Connect cable plug to the fuel injectors 4-6.
3.2. Connect cable plug for cylinder 4 ignition coil -1-.
3.3. Connect cable plug -2- for hall sender.
3.4. Clip on cable rail at the fuel collection pipe -arrow-.
3.5. Connect engine wiring harness.
Fit round connector onto connector bracket and turn clockwise until it reaches the locking point.
3.6. Secure engine wire harness with tie-wraps.
CAUTION:
Low load capacity of pipe and line connections.