911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Preliminary work
1. Disconnect battery.
2. Remove door trim panel. Refer to Removing and installing door trim panel, front
General warning notes
Safety instructions for head airbag unit
WARNING: Removing and installing airbag unit.
-
Danger of injury and material damage if airbag units are not handled correctly.
-
Always observe the safety regulations for handling airbag units. Refer to Safety regulations for handling airbag and seat-belt
pretensioner units
-
Disposal regulations for airbag units must be observed. Refer to Disposal of airbag and seat-belt pretensioner units
-
If removed for an extended period, the airbag unit must be stored in a safe place.
-
Remove ignition key. Disconnect the battery. Route or insulate the ground strap so that all contact with a ground carrier (e.g. body,
seat frame) is avoided. Refer to Work instructions after disconnecting the battery
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
Removing head airbag unit
WARNING: Removing and installing airbag unit.
-
Danger of injury and material damage if airbag units are not handled correctly.
-
Always observe the safety regulations for handling airbag units. Refer to Safety regulations for handling airbag and seat-belt
pretensioner units
-
Disposal regulations for airbag units must be observed. Refer to Disposal of airbag and seat-belt pretensioner units
-
If removed for an extended period, the airbag unit must be stored in a safe place.
-
Remove ignition key. Disconnect the battery. Route or insulate the ground strap so that all contact with a ground carrier (e.g. body,
seat frame) is avoided. Refer to Work instructions after disconnecting the battery
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
1. With a screwdriver, carefully release the locking element of the plug connection for the airbag unit and remove the plug from the airbag module.