911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
2. Unscrew the three fastening nuts -1- and remove the ground lead -2-.
3. Remove the airbag unit
Installing head airbag unit
WARNING: Removing and installing airbag unit.
-
Danger of injury and material damage if airbag units are not handled correctly.
-
Always observe the safety regulations for handling airbag units. Refer to Safety regulations for handling airbag and seat-belt
pretensioner units
-
Disposal regulations for airbag units must be observed. Refer to Disposal of airbag and seat-belt pretensioner units
-
If removed for an extended period, the airbag unit must be stored in a safe place.
-
Remove ignition key. Disconnect the battery. Route or insulate the ground strap so that all contact with a ground carrier (e.g. body,
seat frame) is avoided. Refer to Work instructions after disconnecting the battery
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
1. Position airbag unit on the door unit carrier.
2. Tighten the two outer fastening screws -1-. Tightening torque: 7.5 ftlb.
3. Tighten fastening screw -1- and ground lead -2-. Tightening torque: 7.5 ftlb.
4. Connect the electrical plug to the airbag unit and lock.