911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Installing front three-point belt
INFORMATION:
-
Ensure that belt strap can run properly.
-
The seat-belt pretensioner may only be installed when the ground terminal of the vehicle battery is disconnected.
-
The vehicle battery may only be re-connected after the re-installation of the belt has been completed.
1. Install seat-belt pretensioner. Observe direction of travel.
2. Tighten fastening screw -arrow B-. Tightening torque: 50 Nm (37 ftlb.)±10 %
3. Insert electric connector -2- into the seat-belt pretensioner -arrow A-.