911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
/f6-3.6l_turbo/Page-541010.png)
10. Loosen ground point under the passenger's seat -54-.
10.1. Screw off fastening nut and remove ground straps.
11. Unclip wire harness at door sill.
12. Release and disconnect plug connection between main wire harness and wire harness for door, left and right -59 and 60-.
13. Release and pull off connector for gateway control unit -65-.
14. Release and pull off connectors for KESSY/PAS control unit -66 and 67-.
15. Release and pull off connector for stop light switch -68-.
16. Release and pull off connector for pedal sensor -69-.
17. Loosen ground point under the unit carrier -76-.
17.1. Screw off fastening nut and remove ground straps.
18. Release and pull off connector for tilt sensor control unit -77-.
19. Disconnect plug connections between main wire harness and wire harness for heater/air-conditioning unit -79 and 80-.
19.1. Release lower plug connection on heater/air-conditioning unit -Arrows a- and disconnect.
19.2. Release upper plug connection on heater/air-conditioning unit -Arrows a- and disconnect.
