911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
4. Install transmission support.
4.1. Position the transmission support and secure with the four fastening screws and the two fastening nuts. - Tightening torque: 65 Nm (48 ftlb.)
4.2. Lower transmission jack WE WE1082 and remove from under the vehicle.
5. Screw down B+ line -3- at box for B+ line -4-.
5.1. Insert B+ line into the box and tighten with the fastening nut -Arrow A-. - Tightening torque: 23 Nm (17 ftlb.)
5.2. Close box for B+ line on transmission -Arrow B-.
6. Fasten B+ lead -3- at centre tunnel.
6.1. Push B+ line under the carpet in the direction of travel.
6.2. Insert B+ line into the two holders -arrows-.
7. Clip in B+ line -3- at unit carrier.
7.1. Push B+ line through the unit carrier and across the footwell air vent.
7.2. Clip in B+ line -arrow- at unit carrier with the retaining clip.