911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Differential Output Shaft: Service and Repair
Removing and Installing Front Halfshaft Flange
Removing and installing front halfshaft flange
Preliminary work
Danger
Vehicle raised incorrectly.
Danger of fatal injury or material damage should the vehicle fall down.
-
Raise the vehicle at the prescribed jacking points.
1. Jack and raise the vehicle at the prescribed jacking points.
2. Remove front underbody panelling.
3. Remove front drive shaft.
4. Place oil collection pan under the transmission.
Removing front halfshaft flange
1. Lever off halfshaft flange with a mounting lever.
Halfshaft flange
Installing front halfshaft flange
Replacing circlip
1. Install halfshaft flange.
1.1.
Replace circlip -A- for the halfshaft flange. To do this, clamp the flange in the vice with a hexagon-head bolt -B- and press the circlip out with
the new circlip -A-.
1.2.
Grease circlip -A- for easier fitting.
1.3.
Tap halfshaft flange -arrow- into the transmission using a rubber hammer.