911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Fitting sealing ring
Subsequent work
Installing torque converter
Information
Before installing the torque converter, check the hub for scoring. If damaged, the converter must be replaced.
1. Move torque converter up to stop on the transmission input shaft.
Caution
Torque converter installed at the wrong position during fitting
^
Risk of damage to ATF pump
-
Check that the torque converter is installed at the correct position.
-
Check installation position of torque converter.
2. Press torque converter by hand into the converter bell housing and turn until the cut-out of the converter hub clicks into place in the driver of the
impeller. The converter must slip inwards until it makes a noise.
Information
If the locating pins 95951 (long) cannot be inserted as shown, check the torque converter again to ensure that the installation position is correct.
3. Secure torque converter in installation position with locating pin 95951 (long).
Fixing the torque converter
Subsequent work
1. Mount transmission.
2. After reinstalling the engine-transmission unit, the ATF level must be checked, and topped up as required.