911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Disconnecting control units
Removing solenoid and control valve
1. Pull off plastic cover.
2. Remove screw.
3. Remove leaf spring.
4. Pull solenoid and control valve out using pullers, if necessary.
Installing solenoid and control valve
1. Press solenoid and control valve in fully. Ensure that valve sits correctly into position.
2. Position leaf spring and screw in screw.
3. Fit plastic cover.
Reassembling the hydraulic and electrical control unit
1. Position electrical control unit on hydraulic control unit. The guide pin on the electrical control unit must engage in the guide bore of the hydraulic
control unit.
Pin and bore
Subsequent work
1. Install electrohydraulic control unit.