911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Differential Mount: Service and Repair
Removing and installing support for final drive
Preliminary work
Danger
Vehicle raised incorrectly.
^
Danger of fatal injury or material damage should the vehicle fall down.
-
Raise the vehicle at the prescribed jacking points.
1. Jack and raise the vehicle at the prescribed jacking points.
2. Install underbody panelling.
3. Remove the cardan shaft.
4. Remove front final drive.
Removing support for front final drive
Removing support for final drive
1. Unscrew screws -arrows- and remove support.
Removing support for final drive
Installing support for front final drive
Installing support for final drive
1. Fit support with angled side facing upwards.
2. Screw in and tighten screws -arrows-.