911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Cardan shaft threaded joint
3. Press cardan shaft off the transmission flange with two mounting levers if necessary.
4. Pull cardan shaft out of the splines of the central shaft and remove it.
5. Remove bellows from the central shaft.
Bellows
Installing cardan shaft
Information
Always replace bellows.
1. Assembly sleeve P 9255 -A- must be pushed over the shaft splines. Then, lightly lubricate sleeve with Vaseline and slide on bellows as far as it
will go.
Fitting bellows
2. Grease bushing -A- with approx. 3 g of Olysta Longtime 3EP.