911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Differential Output Shaft: Service and Repair
Removing and Installing Short Halfshaft Flange
Removing and installing short halfshaft flange
Preliminary work
1. Raise the vehicle at the prescribed jacking points.
2. Remove right rear wheel.
3. Remove the underbody panel.
Removing short halfshaft flange
Information
Protect drive shafts against mechanical damage (e.g. with a rubber hose that has been cut open).
1. Remove drive shaft on transmission side. To do this, unscrew six internal serration screws joining the drive shaft and halfshaft flange.
Drive shaft
2. Remove spacer ring.
3. Release the two upper control arms at the outside and remove the screws.