911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
/f6-3.6l_turbo/Page-464004.png)
Closing and engaging retaining flap
3. Close the retaining flap and engage it in the retaining frame.
4. Connect electric plug connections on the main wire harness according to color and lock them -a-.
Plugging in and locking electric plug connections
Subsequent work
Subsequent work for transmission control unit (PDK)
Install left door entry guard.
Install rear side trim panel at the left.
1. If the PDK transmission control unit was replaced, the PDK transmission control unit must be programmed and calibrated.
Programming transmission control unit (PDK)
Information
This description applies when a new PDK control unit is used.
Caution
Voltage drop
^
Risk of irreparable damage to control unit
^
Risk of damage to control unit
^
Fault entries in the control unit
^
Coding in the control unit is aborted
^
Malfunctions in control unit, even during programming
-
Prior to disconnecting the control unit, switch off the ignition and remove the ignition key.
-
Ensure that the power supply is not interrupted during programming.
-
Connect a battery charger with a current rating of at least - Nominal value: 40 A to the vehicle battery.
Warning
