911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
-
The convertible top must be in service position or fully open in order to fit the side window.
-
The power window must be in the upper position.
1. Insert the side window -1- through the side section slot from above and into the clamping jaws -2- of the front and rear drivers -Arrows-.
Adjusting rear side window
Adjusting the side window angle in the vehicle's longitudinal direction
INFORMATION:
-
Moving the side window into the clamping jaws on the receiving rollers equalizes the angle of the side window with respect to the door window.
-
The bottom edge of the window must lie against the receiving rollers in the clamping jaws.
1. Adjust the side window in accordance with the contour of the door window.
Gap dimension E: 9 mm±1 mm
2. Tighten fastening nuts -arrows- on clamping jaws to secure side window. Tightening torque: 8.5 Nm (6.3 ftlb.)±1.5 Nm (±1 ftlb.)