911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Adjusting the lower stop of the power window unit
INFORMATION:
-
It is possible to adjust the height of both lower stops, but these should only be adjusted synchronously.
-
The adjustment is only possible when the side window is lowered.
3. Insert hexagon-socket wrench -1- from above. Adjust the height by turning the screws -2-.
4. Insert rear window inner seal -1- into rear side section slot from above -arrow A- and position on the convertible top support or belt guide section.
5. Insert and tighten front and rear fastening screws -2- ( -arrows B- ). Tightening torque: 10 Nm (7.5 ftlb.)
Subsequent work
1. Install rear side trim panel. Refer to 707519 Removing and installing rear side trim panel.
2. End service position. Refer to IN -Convertible top service position
INFORMATION: Only for vehicles with hardtop.
3. Install hardtop. Refer to Removing and installing hardtop.
INFORMATION: Only for vehicles with hardtop.
4. Adjust the hardtop. Refer to Adjusting hardtop