911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
4. Insert the deflection fitting -5- into the belt guide section -arrow C-. Screw in and tighten fastening screws -6-. Tightening torque: 50 Nm (37 ftlb.)
Installing hydraulic cylinder
CAUTION: Damage to hydraulic lines.
-
Do not bend, trap or crush hydraulic lines when removing and installing.
-
Pay special attention when routing hydraulic lines in the clips
1. Position hydraulic cylinder -6- with the lever on the convertible-top support. Insert potentiometer fork into the pin of the hydraulic housing (on the
left side only).
Lay hydraulic line -Figure A- in the clip under the water drain hose. In -Figure B- and -Figure C- press the hydraulic lines into the clips. Tighten
fastening nuts -5-. Tightening torque: 17 Nm (13 ftlb.)± 2 Nm (±1.5 ftlb.)
2. Fit lever -2- and secure with retaining clip -1-.