911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
/f6-3.6l_turbo/Page-964006.png)
1. Pull off the seal -4-. Remove adhesive residues with cleaning solution -H1-.
Removing adhesive from the windscreen
INFORMATION:
-
Only if the windscreen is re-installed
-
The remaining adhesive helps new adhesive to stick. Keep cut surfaces clean and free of grease and do not clean with cleaning solution.
1. Equip cutting device -C- with the flashing knife -D- and remove the remaining adhesive from the windscreen, ensuring that a surface coating of
adhesive remains.
Fitting windscreen seal
1. Stick seal -4- to the windscreen -5- from one edge along the entire border.
Marking the bonding area
INFORMATION: Only if the windscreen is new and does not have a preliminary coat
1. Before applying the adhesive, mark the course of the adhesive bead in accordance with the dimensions -E- = 160 mm, -F- = 30 mm on the left and
right on the lower edge of the windscreen.
