924 S L4-2479cc 2.5L (1986)
Trailing Arm: Service and Repair
Disassembling
1. Press out rear wheel shaft.
2. Press out seal with a tire iron.
3. Remove circlip. Knock out ball bearing and roller bearing with a suitable mandrel. Openings opposite each other in the wheel bearing housing can
be used to make disassembly easier;
Assembling
1. Check rubber/metal mount, bearings, seals, wheel shaft and spacers for wear, damage or scoring, replacing damaged parts.
2. Press in ball bearing against stop.
3. The axial play of rear axle bearings can be adjusted to 0-0.05 mm by thickness of circlip. The following circlips are available.
2.00 mm
2.05 mm