924 S L4-2479cc 2.5L (1986)
2.10 mm
2.15 mm
2.20 mm
4. Install thinnest circlip (2.00 mm) and drive against bearing outer race with Special Tool VW 415a. Measure gap between circlip and groove upper
edge at several points.
5. Install circlip with correct thickness and make sure it fits correctly.
Example:
Initially installed circlip
2.00 mm
0.10 mm feeler gauge blade fits in gap
+0.10 mm
0.15 mm feeler gauge blade does not fit
Required circlip thickness
2.10 mm
6. Lubricate ball bearing with multi-purpose grease. Drive in seal with Special Tool VW 433 (with trailing arm on wood support) or with VW 415a,
402, 412 and 441 until against stop.
Pack space between sealing lips with a multipurpose grease
Note: Approx. 80 grams of grease in wheel bearing housing and in wheel bearings.
7. Press in rear wheel shaft (do not forget spacer).