944 S L4-2479cc 2.5L DOHC (1987)
18.
Remove rear bracket.
19.
Unbolt and remove chain tensioner.
Note: Chain-tensioner plunger is spring loaded. When removing, compress plunger and after removal hold in this position with a piece of wire or
a retaining clamp.
20.
Remove bearing cover from cylinders 1 + 3
Hold both camshafts in the bearings with Special Tool 9226. Undo and remove front double bearing bridge and bearing cover.
Note: The rear double bearing bridge may remain on the cylinder head.
21.
Undo Special Tool evenly, remove both camshafts with chain and lay together on one side.
22.
Undo cylinder head. Undo in sequence: from outside to inside.
23.
Remove cylinder head.
Note: If oil has been mixed with water, the cylinder head must be subjected to a thorough visual inspection (hairline fractures). At the same time,
check the cooling system for leaks. Use test unit VW 1274 above the expansion tank for the leak test (max. 1 bar). The camshaft cover must be
removed for visual inspection.
