Boxster (986) F6-2.5L (1998)
silicone on the cylinder-head cover. Refer to: Sealing cover for camshaft housing (cylinder head cover).
Carefully place the cylinder head cover in the correct position so that the sealing bead is not damaged. Screw two studs or centering pins into the
corners of the cylinder head as centering aids.
Immediately remove silicone material emerging in the area of the camshaft closure cap.
19. Remove holding-down device 9624 from the cylinder head.
Note Fine adjustment of the camshafts is performed after installation of the camshafts in cylinder bank 4 - 6.
Installing camshafts of cylinder bank 4 - 6
1. Turn engine to installation position on assembly support. Remove fixing pin. Advance crankshaft 360° clockwise until the bore 1 OT (top dead
center) in the belt pulley is aligned with the fixing bore on the crankcase. Position or fix with fixing pin (short) of special tool 9595.
1.1 Turn engine 90° counterclockwise on the assembly support until cylinder bank 4 - 6 faces up.
2. Fit cylinder head. Observe identification on the cylinder head.