Boxster (986) F6-2.7L (2000)
/f6-2.7l/Page-1262001.png)
Blower Motor: Service and Repair
Remove and install heater/fresh-air blower motor with installed heating/fresh-air unit
Removal
1. Remove footwell bulkhead and right air guide. Pull off electrical plug connection on the blower motor and remove wire from the holder.
Removing Heater/Fresh-Air Blower Motor
The figure shows the heating/fresh-air unit when removed.
2. Pull off electrical plug connection on the ballast resistor and undo both fastening screws on the housing lid.
The ballast resistor and housing lid are a spare part.
