Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-823004.png)
11. Select Air conditioner and code with F8.
12. Select Tuner parameters and code with F8.
13. Select ASK amplifier and code with F8.
14. Select Loudness and code with F8.
15. Select Factory settings and code with F8.
16. In the menu CDR24, change to MOST actual installed components list; here a version (e.g. CD changer) installed in the vehicle must be displayed
17. Change to MOST required installed components list; here too the same version (e.g. CD changer) must be displayed - if this is not the case, select
the version and code with F8.
18. Select Required & Actual configuration and press the >>.
19. Compare the Actual/Required listing. Use F8 to start Mapping. All installed audio components must now be listed with a plus under
Actual/Required. If this is not the case, the versions in the MOST actual installed components list or MOST required installed components list
must be coded manually.
20. Read out fault memory and erase if required.
21. Use << to quit the menu CDR24.
22. Remove ignition key, close and lock vehicle, then unlock and switch on ignition
23. In the menu CDR24 select Control unit replacement and perform the functions Read codes and Write codes.
24. Read out the fault memory again and erase as necessary.
25. Car radio is now taught.
