Boxster S (987) F6-3.4L (2008)
1. Check the heat shields on the vehicle before fitting the rear spoiler and replace the heat protection shield if necessary. Check that the heat shields
are properly fitted and correct if necessary. Refer to Removing and installing rear bumper
2. Plug in electrical plug connection -4-.
3. Position rear spoiler -2- on the vehicle
4. Screw in fastening screws -1- above and below on the rear apron -2- and tighten to tightening torque. Tightening torque: 2 ftlb.
5. Engage retainer plate -3- in square opening.