Boxster S (987) F6-3.4L (2008)
6. Screw in fastening screws -1- laterally on the rear apron -2- and tighten to the specified torque. Tightening torque: 2 ftlb.
Dimensions of tailpipes
Gap dimension of tailpipe
1. Check gap dimensions of tailpipes -1- to rear apron -2-, if necessary, adjust tailpipes -1-.
Projection from rear spoiler: -Y = 26.2 ± 2 mm-.
Distance from rear spoiler: -Z = 27 mm-.
Centre distance at the sides evenly to the left and right.
Subsequent work
1. After rear apron assembly, check heat protection shields for correct assembly, if necessary, correct. Refer to Removing and installing rear bumper
2. Check rear gap dimensions, adjust if necessary. Refer to diagram of body gap dimensions
3. Install rear apron. Refer to Removing and installing rear spoiler
4. Install rear light on right and left. Refer to Removing and installing rear light
Removing and Installing Rear Bumper Overrider
Removing And Installing Rear Bumper Overrider
Preliminary work
Remove rear apron. Refer to Removing and installing rear apron
Removing rear bumper overrider
Removing rear bumper horn