Boxster S (987) F6-3.4L (2008)
Installing windstop
Fitting fastening parts
INFORMATION: If the windstop is retrofitted, three fastening parts must be fitted for the centre windstop.
1. Remove trim for roll-over bar. Refer to Removing and installing trim panel for roll-over bar
2. Position the two fastening parts in the upper area of the roll-over bar -1- at the existing holes and rivet them in place -2-.
3. Mark the fastening part -1- centrally on the back of the trim for the roll-over bar, drill and rivet in place -2-.