Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-943022.png)
Use a plastic wedge -4- to press in from the centre outwards.
2. After pressing the convertible top covering -1- into the tension bow -3-, check the centre position once more and correct if necessary.
Fastening convertible-top covering on the inside
1. Close convertible top.
2. Stretch convertible top covering -2- and fasten Velcro fastener -1- in groove at rear of roof frame.
3. Pull inlet aid -3A- inwards and, at dimension -X= 85 mm-, tighten the fastening screw -1- with washer -2-. Tightening torque : 2.8 Nm (2.0 ftlb.)
