Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-568003.png)
Information on PCCB brake pads
Since the production launch, Pagid P40-2 brake pads with -brake-piston damping plates- have been fitted on the rear axle for PCCB brakes.
Damping plates in brake pistons
With the introduction of modified brake pads - Pagid P40-3 - the brake-piston damping plates are no longer used (refer to the Parts Catalogue for
information on use/allocation).
Some brake-piston damping plates are no longer used
Preliminary work
Remove wheel.
Removing rear brake pads - PCCB brakes
The core of the warning contact wire must not be left exposed! Worn insulation is not important!
If necessary, remove a little brake fluid from the reservoir by suction in order to prevent an overflow when the disc brake pads are pushed back!
1. Remove retainer (securing clip) -Arrow- at the top of the retaining pin and move retaining pin -Direction arrow- inwards.
