Boxster S (987) F6-3.4L (2008)
Coolant tank tilted in direction of travel
Warning
Coolant is hazardous to health.
^
Risk of skin irritation.
-->
Wear protective gloves and goggles.
-->
In the event of contact with the skin or eyes, wash immediately with plenty of water.
4. Remove remaining coolant from the tank and absorb any escaping coolant with a cloth.
Installing coolant tank
Installing coolant tank
Warning
Coolant is hazardous to health.
^
Risk of skin irritation.
-->
Wear protective gloves and goggles.
-->
In the event of contact with the skin or eyes, wash immediately with plenty of water.
Information
To facilitate assembly of coolant pipes and hoses, smear with Kluber Syntheso Glep or alternatively Kluberplus S06-100 assembly gel (available in
the Porsche Parts Catalogue).
Information
When fitting a spring band clamp, make sure that the spring band clamp is positioned between the two markings.
1. Guide coolant tank -1- into the engine compartment, tilt it 180° against the direction of travel and fix it in place in the holder -2- and guides -3-.
Coolant tank tilted against direction of travel
2. Work on top of coolant tank -1-:
2.1.
Slide on coolant hose -1-, position spring band clamp -2- between the markings -3- and fit it at this position.
2.2.
Slide on breather hose -3-, position spring band clamp -2- between the markings and fit it at this position.
2.3.
Slide on breather hose -5-, position spring band clamp -4- between the markings and fit it at this position.