Boxster S (987) F6-3.4L (2008)
Lower fastening screw
6. Tighten the fastening nuts on the body studs --> Tightening torque: 23 Nm (ftlb.) (17). Tighten fastening screw M6 x 16 (outer torx) for hose
holder --> Tightening torque: 10 Nm (ftlb.) (7.5).
7. Push spring band clamps on to radiator flanges and fit radiator hoses to the flanges. Move engaged spring band clamps into installation position
and loosen using a water-pump pliers (use a screwdriver as well, if necessary) and then fasten again -arrows-.
Radiator connections
8. Fit radiator vent line to the flange -1- and clip vent line into the plastic holder -2-.
Vent line
9. Connect cable plug for fan motor -arrow-.