Boxster S (987) F6-3.4L (2008)
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
1. Unscrew fastening screw -2- on compressor, pull out line on compressor and remove it from support -7-.
2. Unscrew fastening nut -5- on cable holder, open cable holder and pull line out of rubber mounting -6-.
3. Unscrew fastening screw -4- on connection point and pull out line.
4. Remove line downwards from the engine area.
Installing compressor/evaporator line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
1. Insert line from below into engine compartment.
2. Insert line into evaporator line and secure using the fastening screw -4-. - Tightening torque: 14 Nm (10.5 ft. lbs.)