Boxster S (987) F6-3.4L (2008)
2. Screw down B+ line -3- at box for B+ line -4-.
2.1. Insert B+ line into the box -Arrow A- and tighten with the fastening nut. - Tightening torque: 23 Nm (17 ft. lbs.)
2.2. Close box for B+ line on engine -Arrow B-.
3. Fasten B+ line -3- at centre tunnel.
3.1. Push B+ line under the carpet in the direction of travel.
3.2. Insert B+ line into the two holders -arrows-.
4. Clip in B+ line -3- at unit carrier
4.1. Push B+ line through the unit carrier and across the footwell air vent.
4.2. Clip in B+ line with retaining clip -arrow- at unit carrier.
5. Clip in B+ line -3- at heater/air-conditioning unit.
5.1. Secure B+ line to main wire harness with two new tie-wraps.
5.2. Clip in B+ line at heater/air-conditioning unit with the tie-wraps.
Installing B+ line from starter to engine connection point