Boxster S (987) F6-3.4L (2008)
Camshaft Position Sensor: Service and Repair
Removing And Installing Hall Sender
Technical value
Preliminary work for removing hall sender
1. If the hall sender for cylinder bank 1 -3 is removed, the rear wall cover must be removed.
Removing hall sender
DANGER:
Vehicle raised incorrectly.
-
Danger of fatal injury or material damage should the vehicle fall down.
-
Raise the vehicle at the prescribed jacking points.
1. Release and disconnect cable plug -1-.
2. Remove hall sender -3- by unscrewing the Torx screw (M6 x 16) -2-.
Installing hall sender