Boxster S (987) F6-3.4L (2008)
1. Insert the optical contact -A and B- in the connector until it engages audibly.
2. Lock the secondary locking and check the optical contacts for tightness.
Removing and installing optical contacts on socket side
1. Release the spring cap on both sides using the press-out and unlocking tools for tab and round plug connectors of all sizes NR.155 and remove it.
2. Remove optical waveguide module from connector.
3. Position the press-out and unlocking tools for flat-type and round plug connectors of all sizes NR.155 for releasing the contact locking mechanism
of the optical waveguide module and lift up the locking mechanism.
4. Carefully pull on the optical waveguide -A and B- in -direction of arrow-. If it is not possible to pull out the optical waveguide, check again if the
locking mechanism is completely released.
Perform visual inspection of locking mechanisms, connector housings and contacts for possible damage, and exchange the damaged parts, if
necessary.
Installing optical contacts on socket side
Remove the dust boot right before plugging.
Check the proper condition of the contact.