Boxster S (987) F6-3.4L (2008)
At a force of 10 N (7.5 lb.) the springs installed in the connection point will be compressed. This leads to an increase in attenuation, which could lead to
system impairment and system failure. Therefore a maximum force of 10 N (7.5 lb.) may be used to pull on optical waveguides at connection points.
1. Insert optical contact -B- into the optical waveguide module until it is felt to engage, and check the optical contact is seated securely.
2. Insert optical waveguide module into the connection point on the socket side.
3. Slide the spring cap on the connection point until it can be felt to engage -arrow-.