Boxster S (987) F6-3.4L (2008)
Throttle Body: Service and Repair
Removing And Installing Throttle Body
Technical values
Preliminary work for removing throttle body
1. Place protective covers on the vehicle to avoid damaging the body.
2. Remove engine compartment lid.
Removing throttle body
1. Remove hose for oil separator. To do this, disengage and remove rapid-action couplings -arrows-.
2. Undo four screw-type hose clamps -1- on distributor pipe.
3. Unscrew hexagon nut (M6) -arrow-.
4. Undo spring band clamp and pull off hose -2-.
5. Undo spring band clamp -1- on the rubber sleeve of the hot-film mass air flow meter.
6. Move rubber sleeves in the direction of the intake-air distributor.
7. Remove throttle housing and distributor pipe and turn upwards.
8. Release cable plug -2- on electronic throttle adjuster and remove it.
9. Unclip wire -3-.