Boxster S (987) F6-3.4L (2008)
10. Pull off vacuum line -1- on vacuum modulator.
11. Unscrew four Torx screws (M6 x 50) -arrows- on throttle housing.
Installing throttle body
1. Replace sealing ring -arrow- . Coat sealing ring lightly with Optimol MP3 assembly grease.
2. Position four Torx screws (M6 x 50) -arrows- and tighten them. Tightening torque: 7.5 ftlb.
3. Connect vacuum line -1- on vacuum modulator.
4. Clip wire -3- into the cable holder.
5. Connect cable plug -2- on electronic throttle adjuster.
6. Position throttle housing between the intake-air distributors.
7. Push on rubber sleeves.
8. Push rubber sleeve from hot-film mass air flow meter pipe to throttle valve.
9. Tighten screw-type hose clamp -1-.