Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-629010.png)
93 - Power distributor
94 - 95 - Plug connection between main wire harness and wire harness for heater/air-conditioning unit
96 - 97 - Connector for garage door opener control unit
98 - Connector for interior light
99 - Latching hook microswitch connector
100
- Plug connection for rain sensor
101
- 102 - Plug connection for make-up mirror, left and right
103
- 107 - Connector for antenna unit, left and right
1. Disconnect plug connections for main wire harness to rear wire harness -33 and 34-.
1.1. Release plug connections for main wire harness to rear wire harness -35 and 36- and -arrows A- disconnect.
2. Disconnect plug connections for main wire harness to engine wire harness.
2.1. Release plug connections for main wire harness to engine wire harness -arrows A- and disconnect -arrows B-.
2.2. Release sockets for main wire harness -arrows C- and push down from relay carrier -arrows D-.
3. Release connector for rear vertical sensor -37- and pull it off.
4. Release and pull off connector on DME control unit -38 and 39-.
5. Loosen ground point in luggage compartment -40-.
5.1. Screw off fastening nut and remove ground strap.
6. Release and pull off connector on rear angle sensor for range adjustment -42-.
7. Remove rubber sleeves -43-.
