Boxster S (987) F6-3.4L (2008)
18. Install front cover.
19. Install front wheel housing liner on left and right.
20. Installing front-end control unit
21. Install trim panels for front luggage compartment.
22. Install loudspeaker amplifier.
23. Install navigation unit with retaining frame.
24. Install CD changer.
25. Install plenum panel cover.
26. Install battery.
Removing and Installing Rear Wire Harness
Removing And Installing Rear Wire Harness
Technical values
Preliminary work
1. Disconnect battery.
2. Remove rear luggage-compartment lining.
3. Remove relay carrier.
4. Remove rear lid-release motor.
5. Remove rear spoiler.
Removing rear wire harness
1
- Plug connection for rear wire harness to engine wire harness
2
- Plug connection for rear wire harness to main wire harness on the left
3
- Plug connection for rear wire harness to main wire harness on the right
4
- Connector for rear light, left and right
5
- Ground point
6
- Plug connection for spoiler drive engine
7
- Plug connection for rear lid lock
8
- Connector for rear lid-release motor
9
- Plug connection for rear apron wire harness
10
- Connector on sender for coolant-level indicator
11
- Line holder
12
- Rubber sleeve
13
- Retaining clip
14
- Line holder