Boxster S (987) F6-3.4L (2008)
2. Fit connector -11- on central plug.
3. Route wire harness for backrest -A- and secure with new tie-wraps -12-.
4. Push connector -9- onto air cushion control valve until it engages firmly.
5. Push plug connection -8- onto motor for air cushion until it engages firmly.
6. Attach connector -7- to control unit for memory seat adjustment until it engages firmly.
7. Push plug connection -6- onto air cushion switch until it engages firmly.
8. Connect plug connection -5- on motor for lumbar support adjustment until it engages firmly.
9. Attach connector -4- to motor for backrest adjustment until it engages firmly.
10. Push connectors -2 and 3- onto sensors for lumbar support until they click into place.
11. Push connector -1- onto control valve for lumbar support adjustment until it engages firmly.
Fitting foam part
INFORMATION:
-
Observe the installation position of the hoses.
-
Make sure that the hoses are not pinched. Insert hoses exactly into the cut-outs on the foam part.
1. Fit foam part -1- at the headrest.
Installing backrest side support
INFORMATION:
-
Observe hose routing.
-
In vehicles with lumbar support, make sure the hoses are routed correctly in the area of the backrest side support.
1. Fit backrest side support -2- and screw down with the four fastening screws -1-.
Installing support for left backrest side part
INFORMATION:
-
Observe hose routing.
-
In vehicles with lumbar support, make sure the hoses are routed correctly in the area of the backrest side support.
1. Insert support for backrest side part -2- and secure with the four fastening screws -1-.