porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Procedures|Page 2857 > < Procedures|Page 2855
Page 81
background image

26. Unscrew ground strap -51-.

26.1. Screw off fastening nut and remove ground strap.

27. Release and pull off connector on DME control module -52 to 54-.
28. Release and pull off connector on Tiptronic control module -55-.

INFORMATION:  Only on the Cayman.

29. Unclip wire harness to Tiptronic control module and DME control module at the two holders in the area of the service flap.
30. Remove grommet -56- and pull through the engine wire harness in direction of engine compartment.
31. Unclip engine wire harness at the tie-wraps -57-.

31.1. Unclip tie-wrap on the secondary pump.
31.2. Unclip tie-wrap at the branch (throttle valve, secondary pump, coolant change-over valve).
31.3. Unclip tie-wrap at cable duct in area of grommet.

32. Remove cable duct on the left and right.

32.1. Unscrew fastening screw of cable duct on the left and right -Arrow A-.
32.2. Unclip cable duct on the left and right -Arrow B-.
32.3. Remove cable duct on the left and right -Arrow C-.

33. Remove centre cable duct.

33.1. Unscrew fastening screws, unclip cable duct -arrow- and remove it.

34. Remove wire harness for engine.

Procedures|Page 2857 > < Procedures|Page 2855