Boxster S (987) F6-3.4L (2008)
29. Screw down ground straps -22-.
29.1. Position ground straps -22- and screw down with the fastening screw. - Tightening torque: 10 Nm (7.5 ft. lbs.)
30. Push on connectors of the two solenoid hydraulic valves (valve lift control) -19 to 20- until they are felt to engage.
31. Push on connectors of the two solenoid hydraulic valves (camshaft timing) -17 to 18- until they are felt to engage.
32. Push on connectors of the two knock sensors -15 to 16- until they are felt to engage.
33. Push on connectors of the six fuel injectors -7 to 12- until they are felt to engage.
34. Push on connectors of the six ignition coils -1 to 6- until they are felt to engage.
Subsequent work
1. Install rear luggage-compartment lining.
2. Install intake-air distributor.
3. Install the generator.
4. Install rear cover.
5. Mount rear wheels.
6. Carry out work instruction after disconnecting the battery.
Removing and Installing Wiring Harness For Front-End
Removing And Installing Wire Harness For Front-end
Technical values
Preliminary work
1. Disconnect battery.
2. Remove luggage compartment linings
3. Remove front-end control unit.
5. Remove front apron.
Removing wire harness for front-end