Boxster S (987) F6-3.4L (2008)
Starter Motor: Service and Repair
Removing And Installing Starter
Technical values
Preliminary work
Preliminary work - starter
Remove the engine-compartment lid.
Disconnect battery.
Remove rear wall cover.
Remove centre intake-air distributor with throttle valve.
Removing the starter
Removing starter
WARNING:
If the battery has not been disconnected, battery voltage will be present at the leads during removal and installation.
-
Risk of injury from burns and electric shock.
-
Damage to electrical leads, control units and components due to accidental contact of leads with ground.
-
Disconnect both battery terminals and cover the + terminal.
1. Unscrew fastening nuts for electric line, terminal 30 (M8) and terminal 50 (M6), on solenoid switch, remove the electric lines -1, 2- and place
them to one side.
2. Undo top fastening screw -3-.