Boxster S (987) F6-3.4L (2008)
3. Unscrew lower fastening screw -4- through the rear wall cover opening using a ratchet spanner and an extra long extension.
4. Lift starter out of the bracket.
Installing the starter
Installing starter
WARNING:
If the battery has not been disconnected, battery voltage will be present at the leads during removal and installation.
-
Risk of injury from burns and electric shock.
-
Damage to electrical leads, control units and components due to accidental contact of leads with ground.
-
Disconnect both battery terminals and cover the + terminal.
1. Insert starter into the bracket from above and install with the upper fastening screw -3-. - Tightening torque: 33 ft. lbs.
2. Screw down the lower fastening screw -4- through the tailgate. - Tightening torque: 33 ft. lbs.
3. Position electrical leads on the starter and tighten with fastening nuts -1, 2-. - Tightening torque: 13 ft. lbs. - Tightening torque: 5 ft. lbs.
Subsequent work