porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Power Steering Line/Hose > < Power Steering Fluid|Specifications|Page 3159
Page 2
background image

If assembly work was performed previously, check fluid level with the engine idling and without operating the steering.

Multiple steering movements (maneuvering) with the engine switched off change the fluid level in the reservoir - fluid level rises. In this case, the
engine must be run for at least 20 seconds immediately prior to the fluid level check.

When topping up or filling in Pentosin, make sure that it does not come into contact with the coolant hoses! If coolant hoses come into contact with
Pentosin, thoroughly clean them with water IMMEDIATELY! Replace visibly swollen coolant hoses!

Checking the steering system for leaks (visual check)

With engine idling, turn steering wheel as far as the stop and hold still. The maximum possible line pressure results in this way.

In this position, check all pipe connections for leaks.

Carry out testing for a maximum of --> Period: 10 s. A longer check should always be interrupted by a brief pause after approximately --> Period: 10 s
.

Bleeding the steering system

1. To fill the whole system after the installation of new steering components or lines or after a substantial loss of hydraulic fluid, briefly start the

engine a few times and, when it fires, switch it off again immediately. This procedure causes the fluid level in the reservoir to fall rapidly, so
constantly add more Pentosin. The reservoir must not be sucked dry.

2. If the fluid level in the reservoir does not fall any further when the engine is briefly turned over, start the engine and let it run at idling speed.
3. Rapidly turn the steering wheel from full-lock to full-lock several times so that the air can escape from the cylinders. At the end positions of the

piston, do not pull the steering wheel with more force than is necessary in order to turn the steering (to prevent unnecessary build-up of pressure
initially).

4. Observe fluid level during this procedure. If it continues to fall, add fluid until the level in the reservoir remains constant and no more air bubbles

rise in the reservoir when the steering wheel is turned.

5. Correct the fluid level with the engine at idling speed and without moving the steering.

Power Steering Line/Hose > < Power Steering Fluid|Specifications|Page 3159